Glucose infusion test: a new screening test for vascular access recirculation.
prospective_cohort · Level II
Where this comes from
- Record sourced from PubMed, PMID 10792633.
- No licence information is recorded for this record.
- Because redistribution is not established, this page shows the abstract only. Follow the links below for the full text.
Abstract
Vascular access recirculation is an important cause of diminished dialysis efficiency. We propose a new screening test based on glucose infusion as a tracer for recirculation. The glucose infusion test (GIT) protocol comprises a basal blood sample (A) from the arterial port, a 5 mL bolus of 20% glucose into the venous chamber (time 0), followed by a second sample (B) in four seconds (from 13 to 17 s with QB 300 mL/min) from the same port. The blood glucose level is determined at the bedside on A and B with a reflectance photometer (CV 1.8%). Interpretation of the test is straightforward: If B = A, there is no recirculation, whereas if B > A, recirculation can be calculated from the regression equation: 0.046 x (B - A) + 0.07, obtained from in vitro tests reproducing artificial recirculation at 0, 5, and 10%. To validate this new method in vivo, we compared GIT and the urea test on 39 hemodialysis patients, obtaining a good correlation (r = 0.93). The two tests were considered positive (recirculation present) when the lower 95% confidence intervals were more than zero. Our patients were divided into two groups: those with (22 out of 39, mean recirculation 11.8%) or without recirculation (17 out of 39, mean 0.06%). The urea test did not recognize 7 out of 22 patients because they had a small recirculation below the urea test limit of detection. GIT was more sensitive (detection limit 0.3%), simpler, and immediate in showing the results than the urea test. It is an accurate and low-cost technique for screening and follow-up of vascular access in a dialysis unit.
Medical subject headings
- Catheters, Indwelling
- Glucose
- Renal Dialysis