Use of air displacement plethysmography for estimating body fat in a four-component model.

Abstract

To compare measurements of body density (D(b)) obtained from air displacement plethysmography (AP) and hydrostatic weighing (HW) and to determine the accuracy of substituting D(b) via AP (D(b)-AP) for D(b) via HW (D(b)-HW) in estimating body fatness (%Fat(4C)) and the composition and density of the fat-free mass (Dffm) from a four-component model (fat, mineral, water, and protein). D(b) was measured in 50 young adults using AP and HW. Total body water via deuterium dilution, bone mineral content via dual-energy x-ray absorptiometry, and D(b) were used to estimate %Fat(4C). D(b)-AP and D(b)-HW were highly correlated (r = 0.89, SEE = 0.008 g x mL(-1)), but D(b)-AP (1.065 +/- 0.003 g x mL(-1)) was significantly higher (P < 0.05) than D(b)-HW (1.058 +/- 0.003 g x mL(-1)), resulting in a mean difference of 2.8%fat. Differences between %Fat(4C-AP) (17.8 +/- 1.2%) and %Fat(4C-HW) (19.3 +/- 1.2%) were significant (P < 0.05), but the SD of the differences (2.3%) was low. When D(b)-AP was used in a four-component model in place of D(b)-HW, the calculated Dffm was significantly higher (1.109 +/- 0.002 vs 1.105 +/- 0.002 g x mL(-1)) based on a higher (P < 0.05) protein fraction (22.0 +/- 0.4% vs 20.6 +/- 0.4%) and lower (P < 0.05) water (71.1 +/- 0.4% vs 72.4 +/- 0.4%) and mineral fractions (7.0 +/- 0.1% vs 7.1 +/- 0.1%). AP yields a higher D(b) than HW and may not be a valid method for measuring D(b) or estimating %fat using densitometry. However, due to relatively small bias and low individual error, D(b)-AP is an acceptable substitute for D(b)-HW when estimating %fat with a four-component model in young adults.