Mechanical effect of posterior wire or half-pin configuration on stabilization utilizing a model of circular external fixation of the foot.
biomechanical · Level V
Where this comes from
- Record sourced from PubMed, PMID 15006334.
- No licence information is recorded for this record.
- Because redistribution is not established, this page shows the abstract only. Follow the links below for the full text.
Abstract
Numerous studies have addressed biomechanical characteristics of circular external fixation of long bones. The objective of the present study was to evaluate stabilization of a simulated foot model using external fixation with either calcaneal tensioned stopper wires or half-pins. Fixation configurations of the calcaneus included two parallel wires, two wires crossing at either 30 degrees or 45 degrees, a 4-mm- and 5-mm-diameter single half-pin, or two half-pins inserted at a cross-angle of either 45 degrees or 90 degrees. All frames were tested in axial compression, anteroposterior (AP) bending, and mediolateral (ML) bending. An increase in wire cross-angle improved the axial and AP bending stabilization but had no influence on ML bending. Utilization of a single calcaneal half-pin instead of two cross-wires resulted in a considerable reduction in ML bending stabilization. Frame configurations with two half-pins substantially improved axial and ML bending stabilization. Due to the medial location of the metatarsal wire stopper, an increase in half-pin cross-angle significantly improved ML bending stiffness under lateral foot loading. Under the medial foot loading, however, the half-pin cross-angle had no effect on ML bending stabilization. Replacement of cross-wires with two half-pins significantly improved the AP bending stiffness only when the half-pin cross-angle was reduced to 45 degrees. In all modes of two half-pin frame loading, the half-pin diameter had a substantial effect on foot stabilization. Although the wire cross-angle, half-pin cross-angle, and half-pin diameter affect the stability of foot circular external fixation, the influence of these mechanical parameters on foot stabilization is dependent on the mode and location of loading. The results of the present mechanical testing can be utilized as a useful guideline for the optimization of circular external fixation of the foot.
Medical subject headings
- Bone Nails
- Bone Wires
- Calcaneus
- External Fixators
- Foot
- Fracture Fixation
Anatomy
- foot