A miniature piezoelectric polymer transducer for in vitro measurement of the dynamic contact stress distribution.

Abstract

Previous studies of contact pressure measurement between articular surfaces have been mostly limited to static techniques. The purpose of our study was to develop a new dynamic technique for a direct measurement of the local contact stresses, and to apply the new method to an in vitro cadaver study of the patellofemoral joint pressures. The miniature transducer consists of a 2 mm diameter and 28 microns thick piece of piezoelectric polymer film sandwiched between two stainless steel electrodes of similar diameter. A water-resistant capsule consisting of Teflon film and Hysol epoxy was applied around the transducer. The transducer was 3 mm in diameter and 0.7 mm in thickness. A 3 mm well was made at six locations in the patella, corresponding to superior, middle, and inferior regions of both facets. Six transducers were cemented within each well, flush with the articular cartilage. The transducers were calibrated in situ before and after the experiment. The femur was rigidly fixed to the loading apparatus and the tibia was allowed to flex and extend through a 90 degrees range of motion using an Instron and a pulley system connected to the quadriceps tendon. Q angles of 0, 5, 10 and 15 degrees were established by adjusting the direction of the quadriceps tendon. Stresses ranging from 0.1-1.3 MPa were recorded at various locations. These values varied in flexion and extension. An overall decrease in these stresses was noted after tuberosity elevation up to 1.5 cm, following which increased values up to 1.8 MPa were recorded mostly in the superior section.(ABSTRACT TRUNCATED AT 250 WORDS)