Analysis of photopolymerization behavior of UDMA/TEGDMA resin mixture and its composite by differential scanning calorimetry.

Abstract

The aim of this study was to investigate the extent of polymerization (Ep) in terms of polymerization rate of UDMA/TEGDMA resin mixtures and its composite resin, by using a differential scanning calorimeter (DSC) technique employing a photopolymerization apparatus. The resin mixtures used in this study consisted of urethane dimethacrylate (UDMA) as a base monomer and triethyleneglycol dimethacrylate (TEGDMA) as a low viscosity monomer. The concentration of TEGDMA in the mixed monomer was varied to 0, 20, 40, 60, 80, and 100 mol %. Additionally, using a base monomer consisting of 60 mol % UDMA and 40 mol % TEGDMA, four kinds of composites with silica filler of 0, 20, 40, 60, and 70 wt %, were prepared in this study. The general reaction profile and Ep values were obtained from the DSC curves. Increasing the concentration of TEGDMA resulted in a decrease in the viscosity of the UDMA/TEGDMA mixture, a delay in the time to maximum polymerization rate, and an increase in the Ep values of the resin mixtures. Furthermore, Ep values decreased with increasing filler content between 0 and 60 wt % but did not decrease further between 60 and 70 wt %.