The relation of dosing to clopidogrel responsiveness and the incidence of high post-treatment platelet aggregation in patients undergoing coronary stenting.
rct · Level II
Where this comes from
- Record sourced from PubMed, PMID 15862408.
- No licence information is recorded for this record.
- Because redistribution is not established, this page shows the abstract only. Follow the links below for the full text.
Abstract
We determined the effect of clopidogrel dosing on the incidence of nonresponsiveness (NR) and high post-treatment platelet aggregation (post-PA). We have reported NR after a 300-mg loading dose. Limited information is available on the comparative effect of a 600-mg loading dose on the incidence of NR and high post-PA. Clopidogrel responsiveness and post-PA were measured in patients undergoing stenting (n = 190) randomly treated with either a 300-mg or a 600-mg clopidogrel load. Nonresponsiveness was defined as <10% absolute change in platelet aggregation, and high post-PA was defined as >75th percentile aggregation after 300 mg clopidogrel. Nonresponsiveness was lower after 600 mg compared to the 300-mg dose (8% vs. 28% and 8% vs. 32% with 5 and 20 microM ADP, respectively, p < 0.001). Among the patients with high post-PA after 300 mg clopidogrel, 62% to 65% had NR, whereas after the 600-mg dose, all of the patients with high post-PA had NR. A 600-mg clopidogrel loading dose reduces the incidence of NR and high post-PA as compared to a 300-mg dose. Higher dosing strategies and methods to confirm platelet inhibition should be further investigated in order to optimally use clopidogrel in patients undergoing stenting.
Medical subject headings
- Coronary Stenosis
- Platelet Aggregation
- Platelet Aggregation Inhibitors
- Stents
- Ticlopidine