A solid sulfur cathode for aqueous batteries.
basic_science · Level V
Where this comes from
- Record sourced from PubMed, PMID 17739624.
- No licence information is recorded for this record.
- Because redistribution is not established, this page shows the abstract only. Follow the links below for the full text.
Abstract
Because of its high resistivity and subsequent low electroactivity, sulfur is not normally considered a room-temperature battery cathode. An elemental sulfur cathode has been made with a measured capacity of over 900 ampere.hours per kilogram, more than 90 percent of the theoretical storage capacity of solid sulfur at room temperature, accessed by means of a lightweight, highly conductive, aqueous polysulfide interface through the electrocatalyzed reaction S + H(2)O + 2e(-) --> HS(-) + OH(-). This solid sulfur cathode was first used in a battery with an aluminum anode for an overall discharge reaction 2Al + 3S + 3OH(-) + 3H(2)O --> 2Al(OH)(3) + 3HS(-), giving a cell potential of 1.3 volts. The theoretical specific energy of the aluminum-sulfur battery (based on potassium salts) is 910 watt.hours per kilogram with an experimental specific energy of up to 220 watt.hours per kilogram.