Corrective osteotomy for deformity of the distal radius using a volar locking plate.
case_series · Level IV
Where this comes from
- Record sourced from PubMed, PMID 18780123.
- Also identified by DOI 10.1007/s11552-007-9066-y and PMC identifier 2528980.
- No licence information is recorded for this record.
- Because redistribution is not established, this page shows the abstract only. Follow the links below for the full text.
Abstract
Dorsally angulated malunions of the distal radius have historically been corrected with an opening wedge osteotomy fixed with a dorsal plate. Volar locking plates may facilitate a less morbid approach to corrective osteotomies of the wrist. Eight consecutive patients with an average age of 40 years (range, 15-52 years) underwent correction of a distal radius deformity through a volar approach. Clinical follow-up averaged 17.4 months (range, 7-41 months). Preoperative radiographs revealed an average of 24 degrees of dorsal tilt in patients with dorsal deformity. Postoperatively, their average measurement was <3 degrees of volar tilt. Patients were initially ulnar-positive with an average of 4 mm ulnar-positive variance (range, 2-7 mm). This corrected to less than 1 mm postoperatively. Postoperative disabilities of the arm, shoulder, and hand (DASH), SF-12, and Mayo Wrist scores averaged 10.8, 40.5, and 82.5, respectively. There were no nonunions, and no plates required removal. Distal radius deformity can be effectively addressed through a volar approach with the use of a locking plate.
Anatomy
- radius