Compressive behavior of human bone-cement composites.

Abstract

Current surgical practice in the implantation of cemented total joint arthroplasties generally creates a zone of variable thickness in which polymethylmethacrylate (PMMA) is intermixed with trabecular bone. The authors' objectives in these experiments were to characterize the compressive mechanical properties of this bone-cement composite material. They found that the mechanical properties of bone-cement composite specimens, fabricated under in vitro conditions that would promote nearly complete cement filling, are closer to the properties of trabecular bone than to those of cement. For both low-viscosity cement (LVC) and PMMA specimens, with the cement introduced by either hand-packing or pressurized injection at periods of 2 and 7 minutes, the compressive strengths ranged from 29 MPa to 50 MPa and the compressive moduli from 539 MPa to 1,210 MPa. Cement volume fractions achieved using different filling methods ranged from 76% to 87%. In contrast to previous studies of bone-cement composites using high-density bovine bone, neither mechanical properties nor filling parameters correlated significantly with bone porosity measured prior to filling. The authors expect that the mechanical properties of bone-cement regions created at surgery under less than these ideal in vitro filling conditions will only approach their values as an upper limit. Thus, bone-cement composites created in situ at surgery will also exhibit mechanical properties well below previously assumed values.