Late infections after dynamic stabilization of the lumbar spine with Dynesys.
case_series · Level IV
Where this comes from
- Record sourced from PubMed, PMID 22610441.
- Also identified by DOI 10.1007/s00586-012-2366-0 and PMC identifier 3508231.
- No licence information is recorded for this record.
- Because redistribution is not established, this page shows the abstract only. Follow the links below for the full text.
Abstract
Dynamic stabilization of the spine was developed as an alternative to rigid fusion in chronic back pain to reduce the risk of adjacent segment degeneration. Dynamic neutralization system (Dynesys, Zimmer CH) is one of the most popular systems available, but some midterm studies show revision rates as high as 30 %. Some late infectious complications in our patients prompted us to review them systematically. Propionibacterium recently has been shown to cause subtle infections of prosthetic material. Here, we report on a consecutive series of 50 Dynesys implants. In a median follow-up of 51 months (range 0-91), we identified 12 infectious and 11 non-infectious complications necessitating reoperation or removal of the implant in 17 patients. Material infections occurred after a median of 52 months (2-77) and were due to Propionibacterium alone (n = 4) or in combination (n = 3) in seven out of 11 patients. Clinical presentation combines new or increasing pain associated with signs of screw loosening on conventional X-rays; however, as many as 73.5 % of patients present some degree of screw loosening without being at all symptomatic of infection. The high rate of late infections with low-grade germs and the frequency of screw loosening signs made us suspect a lack of integration at the bone-screw interface. Surgeons should be suspicious if the patient presents a combination of new or increasing pain and signs of screw loosening, and aggressive revision is recommended in these cases.
Medical subject headings
- Bone Screws
- Postoperative Complications
- Reoperation
Anatomy
- lumbar spine