The combined effect of alumina and silica co-doping on the ageing resistance of 3Y-TZP bioceramics.

Abstract

The combined effect of alumina and silica co-doping on the ageing resistance of 3Y-TZP bioceramics was investigated. In order to differentiate between the distinct contributions of two dopants to the overall resistance to low-temperature degradation (LTD), specimens were prepared by infiltration of silica sol into pre-sintered 3Y-TZP pellets, produced from commercially available powders, which were alumina-free or contained 0.05 and 0.25 wt.%. After sintering, specimens were exposed to accelerated ageing in distilled water at 134°C for 6-48 h. X-ray diffraction was applied to quantify the tetragonal-to-monoclinic (t-m) phase transformation associated with the LTD, while a focused ion beam-scanning electron microscopy technique was employed to study the microstructural features in the transformed layer. The results showed that the minor alumina and/or silica additions did not drastically change the densities, grain sizes or mechanical properties of 3Y-TZP, but they did significantly reduce LTD. The addition of either alumina or silica has the potential to influence both the nucleation and the propagation of moisture-induced transformation, but in different ways and to different extents. The co-doped ceramics exhibited predominantly transgranular fracture, reflecting strong grain boundaries (limiting microcracking of the transformed layer), for alumina doping, and rounded grains with a glassy phase at multiple grain junctions (reducing internal stresses) for silica-doped material. These two additives evidently have different dominant mechanisms associated with the deceleration of LTD of 3Y-TZP, but their combination increases resistance to ageing, importantly, without reducing the fracture toughness of this popular biomaterial.