Effects of surfactants on the improvement of sludge dewaterability using cationic flocculants.
basic_science · Level V
Where this comes from
- Record sourced from PubMed, PMID 25347394.
- Also identified by DOI 10.1371/journal.pone.0111036 and PMC identifier PMC3963960.
- No licence information is recorded for this record.
- Because redistribution is not established, this page shows the abstract only. Follow the links below for the full text.
Abstract
The effects of the cationic surfactant (cationic cetyl trimethyl ammonium bromide, CTAB) on the improvement of the sludge dewaterability using the cationic flocculant (cationic polyacrylamide, CPAM) were analyzed. Residual turbidity of supernatant, dry solid (DS) content, extracellular polymeric substances (EPS), specific resistance to filtration (SRF), zeta potential, floc size, and settling rate were investigated, respectively. The result showed that the CTAB positively affected the sludge conditioning and dewatering. Compared to not using surfactant, the DS and the settling rate increased by 8%-21.2% and 9.2%-15.1%, respectively, at 40 mg·L-1 CPAM, 10×10-3 mg·L-1 CTAB, and pH 3. The residual turbidities of the supernatant and SRF were reduced by 14.6%-31.1% and 6.9%-7.8% compared with turbidities and SRF without surfactant. Furthermore, the release of sludge EPS, the increases in size of the sludge flocs, and the sludge settling rate were found to be the main reasons for the CTAB improvement of sludge dewatering performance.