Rapid Software-Based Design and Optical Transient Liquid Molding of Microparticles.
basic_science · Level V
Where this comes from
- Record sourced from PubMed, PMID 26509252.
- Also identified by DOI 10.1002/adma.201503308.
- No licence information is recorded for this record.
- Because redistribution is not established, this page shows the abstract only. Follow the links below for the full text.
Abstract
Microparticles with complex 3D shape and composition are produced using a novel fabrication method, optical transient liquid molding, in which a 2D light pattern exposes a photopolymer precursor stream shaped along the flow axis by software-aided inertial flow engineering.
Medical subject headings
- Computer-Aided Design
- Microspheres
- Optical Phenomena
- Software