Controlling Material Reactivity Using Architecture.
basic_science · Level V
Where this comes from
- Record sourced from PubMed, PMID 26669517.
- Also identified by DOI 10.1002/adma.201504286.
- No licence information is recorded for this record.
- Because redistribution is not established, this page shows the abstract only. Follow the links below for the full text.
Abstract
3D-printing methods are used to generate reactive material architectures. Several geometric parameters are observed to influence the resultant flame propagation velocity, indicating that the architecture can be utilized to control reactivity. Two different architectures, channels and hurdles, are generated, and thin films of thermite are deposited onto the surface. The architecture offers an additional route to control, at will, the energy release rate in reactive composite materials.
Medical subject headings
- Printing, Three-Dimensional