Structural and compositional dependence of the CdTexSe1-x alloy layer photoactivity in CdTe-based solar cells.
basic_science · Level V
Where this comes from
- Record sourced from PubMed, PMID 27460872.
- Also identified by DOI 10.1038/ncomms12537 and PMC identifier 4974465.
- Licence recorded as CC BY.
- The licence permits redistribution, so the abstract is shown in full and the full text is available from the publisher.
Abstract
The published external quantum efficiency data of the world-record CdTe solar cell suggests that the device uses bandgap engineering, most likely with a CdTexSe1-x alloy layer to increase the short-circuit current and overall device efficiency. Here atom probe tomography, transmission electron microscopy and electron beam-induced current are used to clarify the dependence of Se content on the photoactive properties of CdTexSe1-x alloy layers in bandgap-graded CdTe solar cells. Four solar cells were prepared with 50, 100, 200 and 400 nm-thick CdSe layers to reveal the formation, growth, composition, structure and photoactivity of the CdTexSe1-x alloy with respect to the degree of Se diffusion. The results show that the CdTexSe1-x layer photoactivity is highly dependent on the crystalline structure of the alloy (zincblende versus wurtzite), which is also dependent on the Se and Te concentrations.