Medial tilting of the joint line in posterior stabilized total knee arthroplasty increases contact force and stress.

Abstract

Kinematically aligned total knee arthroplasty is based on the concept to represent the premorbid joint alignment with cruciate-retaining implants, characterized by medial tilt and internal rotation. However, kinematic and kinetic effects of kinematically aligned total knee arthroplasty with posterior-stabilized implants is unknown. The purpose of this study was to examine the effect of medial tilting of the joint line with posterior-stabilized implants. A mechanical alignment model, and medial tilt 3° and 5° models were constructed. Knee kinematics and contact forces were simulated using a musculoskeletal computer simulation model. Contact stresses on the tibiofemoral joint and the post area were then calculated using finite element analysis. From 0° to 120° of knee flexion, greater external rotation of the femoral component was observed in medial tilt models (-0.6°, 1.8° and 4.2° in mechanical alignment, medial tilt 3° and medial tilt 5° models, respectively). The peak contact stresses on the tibiofemoral joint and the post area at 120° of knee flexion were higher in medial tilt models. The peak contact stresses on the post area in medial tilt 3° and 5° models were 2.2 and 3.8 times greater than that in mechanical alignment model, respectively. Medial tilting of the joint line causes greater axial rotation even with posterior-stabilized implants, which can represent near-normal kinematics. However, medial tilting of the joint line in total knee arthroplasty with posterior-stabilized implants may have a higher risk for polyethylene wear at the tibiofemoral joint and post area, leading to subsequent component loosening.