Scanning Tunneling Microscopy of an Air Sensitive Dichalcogenide Through an Encapsulating Layer.
basic_science · Level V
Where this comes from
- Record sourced from PubMed, PMID 30354173.
- Also identified by DOI 10.1021/acs.nanolett.8b01978.
- No licence information is recorded for this record.
- Because redistribution is not established, this page shows the abstract only. Follow the links below for the full text.
Abstract
Many atomically thin exfoliated two-dimensional (2D) materials degrade when exposed to ambient conditions. They can be protected and investigated by means of transport and optical measurements if they are encapsulated between chemically inert single layers in the controlled atmosphere of a glovebox. Here, we demonstrate that the same encapsulation procedure is also compatible with scanning tunneling microscopy (STM) and spectroscopy (STS). To this end, we report a systematic STM/STS investigation of a model system consisting of an exfoliated 2H-NbSe<sub>2</sub> crystal capped with a protective 2H-MoS<sub>2</sub> monolayer. We observe different electronic coupling between MoS<sub>2</sub> and NbSe<sub>2</sub> from a strong coupling when their lattices are aligned within a few degrees to essentially no coupling for 30° misaligned layers. We show that STM always probes intrinsic NbSe<sub>2</sub> properties such as the superconducting gap and charge density wave at low temperature when setting the tunneling bias inside the MoS<sub>2</sub> band gap, irrespective of the relative angle between the NbSe<sub>2</sub> and MoS<sub>2</sub> lattices. This study demonstrates that encapsulation is fully compatible with STM/STS investigations of 2D materials.