Biomechanical Evaluation of Cervicothoracic Junction Fusion Constructs.

Abstract

We studied the effect of different cervicothoracic construct design variables on biomechanical stability in vitro. Six fresh-frozen human cadaveric spines (C5-T4) were used. After intact analysis, each specimen was destabilized and reconstructed, with all groups having 4.0-mm pedicle screws placed at T1-T3. The 2 hook-rod constructs included interlaminar hooks at C6 and C7, with either 3.5-mm or 4.0-mm rods (C6-T3). The 2 screw-rod constructs tested included lateral mass screws at C6 and C7, with either 3.5-mm or 4.0-mm rods (C6-T3). The 2 screw-connector-rod constructs tested included lateral mass screws at C6 and C7, with either 3.5-mm or 4.0-mm rods; 1 rod spanned C6-C7 with a connector to a second rod of the same size spanning T1-T3. Global (C6-T3) and intervertebral (C6-C7, C7-T1, T1-T2, and T2-T3) ranges of motion were compared for each construct. In terms of global (C6-T3) stability, 3.5-mm versus 4.0-mm rod constructs were not significantly different, regardless of whether the construct was hook-rod, screw-rod, or screw-connector-rod. The hook-rod constructs provided less stability compared with the screw-rod and screw-connector-rod constructs in lateral bending (P < 0.04) and axial rotation (P < 0.001). The screw-rod constructs demonstrated a similar range of motion to that of the screw-connector-rod constructs, except for significantly less axial rotation at the C6-C7 level with 3.5-mm rods (P = 0.04). We found that the rod diameter of a construct does not appear to significantly influence the biomechanical stability of subaxial constructs. The screw-rod construct resulted in certain biomechanical advantages compared with the screw-connector-rod construct, and both were significantly superior to the hook-rod construct.