Vertical Silicon Nanowire Thermoelectric Modules with Enhanced Thermoelectric Properties.
basic_science · Level V
Where this comes from
- Record sourced from PubMed, PMID 30636421.
- Also identified by DOI 10.1021/acs.nanolett.8b03822.
- No licence information is recorded for this record.
- Because redistribution is not established, this page shows the abstract only. Follow the links below for the full text.
Abstract
Thermoelectric modules based on silicon nanowires (Si-NWs) have recently attracted significant attention as they show an improved thermoelectric efficiency due to a decrease in thermal conductivity. Here, we adopt a top-down fabrication method to dramatically reduce the thermal conductivity of vertical Si-NWs. The thermal conductivity of a vertical Si-NW is significantly suppressed with an increasing surface roughness, decreasing diameter, and increasing doping concentration. This large suppression is caused by enhanced phonon scattering, which depends on the phonon wavelength. The boron- and phosphorus-doped rough Si-NWs with a diameter of 200 nm and surface roughness of 6.88 nm show the lowest thermal conductivity of 10.1 and 14.8 W·m<sup>-1</sup>·K<sup>-1</sup>, respectively, which are 5.1- and 3.6-fold lower than that of a smooth intrinsic nanowire and 14.8- and 10.1-fold lower than that of bulk silicon. A thermoelectric module was fabricated using this doped rough Si-NW array, and its thermoelectric performance is compared with previously reported Si-NW modules. The fabricated module exhibits an excellent performance with an open circuit voltage of 216.8 mV·cm<sup>-2</sup> and a maximum power of 3.74 μW·cm<sup>-2</sup> under a temperature difference of 180 K, the highest reported for Si-NW thermoelectric modules.