Single-Mode Lasing from Imprinted Halide-Perovskite Microdisks.
basic_science · Level V
Where this comes from
- Record sourced from PubMed, PMID 30844247.
- Also identified by DOI 10.1021/acsnano.8b08948.
- No licence information is recorded for this record.
- Because redistribution is not established, this page shows the abstract only. Follow the links below for the full text.
Abstract
Halide-perovskite microlasers have demonstrated fascinating performance owing to their low-threshold lasing at room temperature and low-cost fabrication. However, being synthesized chemically, controllable fabrication of such microlasers remains challenging, and it requires template-assisted growth or complicated nanolithography. Here, we suggest and implement an approach for the fabrication of microlasers by direct laser ablation of a thin film on glass with donut-shaped femtosecond laser beams. The fabricated microlasers represent MAPbBr <sub>x</sub>I <sub>y</sub> microdisks with 760 nm thickness and diameters ranging from 2 to 9 μm that are controlled by a topological charge of the vortex beam. As a result, this method allows one to fabricate single-mode perovskite microlasers operating at room temperature in a broad spectral range (550-800 nm) with Q-factors up to 5500. High-speed fabrication and reproducibility of microdisk parameters, as well as a precise control of their location on a surface, make it possible to fabricate centimeter-sized arrays of such microlasers. Our finding is important for direct writing of fully integrated coherent light sources for advanced photonic and optoelectronic circuitry.