Three-Dimensional Imaging of Beam-Induced Biasing of InP/GaInP Tunnel Diodes.
basic_science · Level V
Where this comes from
- Record sourced from PubMed, PMID 31072098.
- Also identified by DOI 10.1021/acs.nanolett.9b00249.
- No licence information is recorded for this record.
- Because redistribution is not established, this page shows the abstract only. Follow the links below for the full text.
Abstract
Electron holographic tomography was used to obtain three-dimensional reconstructions of the morphology and electrostatic potential gradient of axial GaInP/InP nanowire tunnel diodes. Crystal growth was carried out in two opposite directions: GaInP-Zn/InP-S and InP-Sn/GaInP-Zn, using Zn as the p-type dopant in the GaInP but with changes to the n-type dopant (S or Sn) in the InP. Secondary electron and electron beam-induced current images obtained using scanning electron microscopy indicated the presence of p-n junctions in both cases and current-voltage characteristics measured via lithographic contacts showed the negative differential resistance, characteristic of band-to-band tunneling, for both diodes. Electron holographic tomography measurements confirmed a short depletion width in both cases (21 ± 3 nm) but different built-in potentials, V<sub>bi</sub>, of 1.0 V for the p-type (Zn) to n-type (S) transition, and 0.4 V for both were lower than the expected 1.5 V for these junctions if degenerately doped. Charging induced by the electron beam was evident in phase images which showed nonlinearity in the surrounding vacuum, most severe in the case of the nanowire grounded at the p-type Au contact. We attribute their lower V<sub>bi</sub> to asymmetric secondary electron emission, beam-induced current biasing, and poor grounding contacts.