The effect of NaOCl and heat treatment on static and dynamic mechanical properties and chemical changes of dentine.

Abstract

To determine the effect of heat on flexural strength (FS), maximum strain (MS), storage modulus (SM), tan delta (TD) and chemical changes through micro-Raman spectroscopy of dentine exposed to 2.5% NaOCl or saline. ology: Dentine bars were randomly allocated to 8 test groups. Half (groups 2,4,6,8) were treated with NaOCl for 20 min; the rest (groups 1,3,5,7) remained in saline. FS/MS were measured in groups 1-4 (n = 15) (3/4 were also heated to 200 °C & re-hydrated in saline). Micro-Raman spectroscopy was performed on bars from groups 1-4. SM/TD were measured in 5-8: in 5/6 (n = 10), repeated after heating (200 °C), then following re-hydration; in 7/8 (n = 3) after heating to 25-185 °C. Increase in MS on heat and FS/MS on heat + NaOCl was not significant (P > 0.05). SM increased (P = 0.06) after heat treatment but reduced to initial state after rehydration (P = 0.03). TD did not change (P = 0.4) after heat (200 °C) treatment but rehydration increased it compared with pre-treatment state (P = 0.001). For dentine bars pre-treated with NaOCl, SM did not change (P = 0.6) after heat (200 °C) treatment or rehydration but TD significantly increased (P = 0.02) upon re-hydration compared with pre- (P=0.007), or post- (P = 0.03) heat-treatment states. SM and TD varied between 25-185 °C with no consistent trend amongst the NaOCl pre-treated bars. Micro-Raman only detected chemical changes following NaOCl treatment in the mineral phase. Exposure of dentine bars to heat and NaOCl produced only moderate changes to quasi-static but marked changes to viscoelastic properties, which may be explained by chemical alterations.