Mallet finger - A modified technique using the finger nail as a fixation point for the temporary immobilization of the distal interphalangeal joint - A biomechanical study.

Abstract

The aim of the current biomechanical study was to investigate a newly developed surgical technique for mallet fingers. The new method is based on the Ishiguro method which requires a K-wire through the distal interphalangeal joint for temporary fixation. The new technique avoids the joint trans fixation using a specially designed finger nail holder. This method was compared to the established Ishiguro's technique. For biomechanical testing, 32 paired, fresh-frozen human fingers (Digit II-V) of 4 donors (ages 60 to 71 years) were used. The paired fingers were assigned to either the new method or Ishiguro's technique. The biomechanical testing consisted of a cyclic cantilever bending (2000 cycles, 1-7N) followed by a load to failure test. The groups were evaluated for plastic deformation, stiffness, change in stiffness during cyclic loading, subluxation and failure load by analysing force-deflect data and fluoroscopic images. The nail fixation group showed significantly higher failure loads and stiffness than the trans fixation group. The values of plastic deformation were significantly lower in the nail fixation group. No differences were found in the change of stiffness. No subluxation was found in both groups. In the current biomechanical study, nail fixation performed at least as good as Ishiguro's trans fixation technique. The results and ease of implementation indicate that the newly developed nail fixation technique might be a useful treatment method in daily clinical practice without the need of temporary joint trans-fixation avoiding possible associated problems. To establish this method, clinical trials will be necessary.