Does Unicondylar Knee Arthroplasty Affect Tibial Bone Strain? A Paired Cadaveric Comparison of Fixed- and Mobile-bearing Designs.
biomechanical · Level V
Where this comes from
- Record sourced from PubMed, PMID 32168072.
- Also identified by DOI 10.1097/CORR.0000000000001169 and PMC identifier 7431246.
- No licence information is recorded for this record.
- Because redistribution is not established, this page shows the abstract only. Follow the links below for the full text.
Abstract
Unexplained pain in the medial proximal tibia frequently leads to revision after unicondylar knee arthroplasty (UKA). As one of the most important factors for osteogenic adaptive response, increased bone strain following UKA has been suggested as a possible cause. In this study we: (1) performed a cadaver-based kinematic analysis on paired cadaveric specimens before and after mobile-bearing and fixed-bearing UKA; and (2) simultaneously characterized the strain distribution in the anterior and posterior proximal tibia during squatting. Five pairs of fresh, frozen full-leg cadaver specimens (four male, one female, 64 years to 87 years) were subjected to a dynamic squatting motion on a kinematic rig to simulate joint loading for a large ROM. Forces were applied to the quadriceps and hamstrings during the simulation while an infrared camera system tracked the location of reflective markers attached to the tibia and femur. Tibial cortical bone strain was measured with stacked strain gauge rosettes attached at predefined anterior and posterior positions on the medial cortex. Pairwise implantation of mobile-bearing (UKAMB) and fixed-bearing implants (UKAFB) allowed a direct comparison of right and left knees from the same donor through a linear mixed model. UKAMB more closely replicated native kinematics in terms of tibial rotation and in AP and mediolateral translation. Maximum principal bone strain values were consistently increased compared with native (anteromedial, mean [± SD] peak strain: 311 µε ± 190 and posterior, mean peak strain: 321 µε ± 147) with both designs in the anteromedial (UKAFB, mean peak strain: 551 µε ± 381, Cohen's d effect size 1.3 and UKAMB, mean peak strain: 596 µε ± 564, Cohen's d effect size 1.5) and posterior (UKAFB, mean peak strain: 505 µε ± 511, Cohen's d effect size 1.3 and UKAMB, mean peak strain: 633 µε ± 424, Cohen's d effect size 2.1) region. However, in the anterolateral region of the medial tibial bone, UKAFB demonstrated the overall largest increase in strain (mean peak strain: 1010 µε ± 787, Cohen's d effect size 1.9), while UKAMB (613 µε ± 395, Cohen's d effect size 0.2) closely replicated values of the native knee (563 µε ± 234). In this in vitro cadaver study both UKAMB and UKAFB led to an increase in bone strain in comparison with the native knee. However, in the anterolateral region of the medial tibial plateau, proximal tibial bone strain was lower after UKAMB and UKAFB. Both UKAMB and UKAFB lead to comparable increases in anteromedial and posterior tibial strain in comparison with the native knee. In the anterolateral region of the medial tibial plateau UKA, proximal tibial bone strain was closer to the native knee after UKAMB than after UKAFB. In an attempt to link kinematics and strain behavior of these designs there seemed to be no obvious relation. Further clinical research may be able to discern whether the observed differences in cortical strain after UKA is associated with unexplained pain in patients and whether the observed differences in cortical bone strain between mobile-bearing and fixed unicondylar designs results in a further difference in unexplained pain.
Medical subject headings
- Arthroplasty, Replacement, Knee
- Postoperative Complications
- Reoperation
- Sprains and Strains
- Tibia
Anatomy
- knee
- tibia