Does commercially available shoulder arthroplasty preoperative planning software agree with surgeon measurements of version, inclination, and subluxation?
cross_sectional · Level IV
Where this comes from
- Record sourced from PubMed, PMID 32544424.
- Also identified by DOI 10.1016/j.jse.2020.05.027.
- No licence information is recorded for this record.
- Because redistribution is not established, this page shows the abstract only. Follow the links below for the full text.
Abstract
Preoperative planning with commercially available imaging software in shoulder arthroplasty may allow for improved decision-making and more accurate placement of the glenoid component. A total of 81 consecutive shoulder computed tomography scans obtained for preoperative planning purposes for shoulder arthroplasty were analyzed by commercially available software from 4 companies (Blueprint: Wright Medical, Memphis, TN, USA; GPS: Exactech, Gainesville, FL, USA; Materialise: DJO, Vista, CA, USA; and VIP: Arthrex, Naples, FL, USA) and by 5 fellowship-trained sports medicine/shoulder surgeons. Inclination, version, and subluxation of the humerus were measured in a blinded fashion on axial and coronal sequences at the mid-glenoid. Surgeon measurements were analyzed for agreement and were compared with the 4 commercial programs. Surgeon reliability was acceptable for version (intraclass correlation coefficient [ICC]: 0.876), inclination (ICC: 0.84), and subluxation (ICC: 0.523). Significant differences were found between surgeon and commercial software measurements in version (P = .03), inclination (P = .023), and subluxation (P < .001). Software measurements tended to be more superiorly inclined (average -2° to 2° greater), more retroverted (average 2°-5° greater), and more posteriorly subluxed (average 7°-10° greater) than surgeon measurements. In comparing imaging software measurements, only Blueprint was found to produce significantly different version measurements than surgeon measurements (P = .02). Preoperative planning software for shoulder arthroplasty has limited agreement in measures of version, inclination, and subluxation measurements, whereas surgeons have high inter-reliability. Surgeons should be cautious when using commercial software planning systems and when comparing publications that use different planning systems to determine preoperative glenoid deformity measurements.
Medical subject headings
- Arthroplasty, Replacement, Shoulder
- Shoulder Joint
- Surgeons
Anatomy
- shoulder