Morphological parameters of fourth lumbar spinous process palpation: a three-dimensional reconstruction of computed tomography.

Abstract

The localization of lumbar fourth spinous process (L4-SP) is an important anatomical landmark, and identifying its accurate position is essential for the diagnosis and treatment of waist diseases. Five hundred participants were scanned with positive and lateral computed tomography (CT), which aimed to clarify anatomic characteristics of L4-SP. Anatomical parameters of the surface localization of L4-SP were measured and recorded through a three-dimensional (3D) reconstruction. Five hundred participants were classified into three types according to the position of BC with the iliac spine. There are just 266 that the line between the highest point of the iliac spine on both sides located on L4-SP (type I, 53.20%), 16 above L4-SP (type II, 3.20%), and 218 below L4-SP (type III, 43.60%). BC in type I (15.92 ± 1.30 mm) is longer than type III (15.56 ± 1.32 mm). While the angle combined with AB and BC is different in the three groups, the angle in type I (173.00 ± 4.83°) is larger than that in type II (164.69 ± 5.50°) and type III (159.45 ± 8.39°). Other measurements were not found any significant differences between above. The traditional palpation for L4-SP is not absolutely exact. The accuracy rate is only 53.20%, and the errors may cause serious consequences.