An automated method for defining anatomic coordinate systems in the hindfoot.

Abstract

The absence of a standardized method for defining hindfoot bone coordinate systems makes it difficult to compare kinematics results from different research studies. The purpose of this study was to develop a reliable and robust procedure for defining anatomical coordinate systems for the talus and calcaneus. Four methods were evaluated based upon their anatomic consistency across subjects, repeatability, and their correspondence to functional axes of rotation. The four systems consisted of: 1) interactively identified bony landmarks, 2) a principal component analysis, 3) automatically identified bony landmarks, and 4) translating the tibial coordinate system to the hindfoot bones. The four systems were evaluated on 40 tali and 40 calcanei. The functional axes of rotation were determined using dynamic biplane radiography to image the hindfoot during gait. Systems 2 and 3 were the most repeatable and consistent due to the lack of operator intervention when defining coordinate systems. None of the coordinate systems corresponded well to functional axes of rotation during gait. System 3 is recommended over System 2 because it more closely mimics established bone angles measured clinically, especially for the calcaneus. This study presents an automated method for defining anatomic coordinate systems in the talus and calcaneus that does not rely on manual placement of markers or fitting of spheres to the bone surfaces which are less reliable due to operator-dependent measurements. Using this automated method will make it easier to compare hindfoot kinematics results across research studies.