On-Site Monitoring of Postoperative Bile Leakage Using Bilirubin-Inducible Fluorescent Protein.
case_series · Level IV
Where this comes from
- Record sourced from PubMed, PMID 32909125.
- Also identified by DOI 10.1007/s00268-020-05774-x and PMC identifier 7599156.
- Licence recorded as CC BY.
- The licence permits redistribution, so the abstract is shown in full and the full text is available from the publisher.
Abstract
Bile leakage is the most common postoperative complication associated with hepatobiliary and pancreatic surgery. Until now, however, a rapid, accurate diagnostic method for monitoring intraoperative and postoperative bile leakage had not been established. Bilirubin levels in drained abdominal fluids collected from 23 patients who had undergone hepatectomy (n = 22) or liver transplantation (n = 1) were measured using a microplate reader with excitation/emission wavelengths of 497/527 nm after applying 5 µM of UnaG to the samples. UnaG was also sprayed directly on hepatic raw surfaces in swine hepatectomy models to identify bile leaks by fluorescence imaging. The bilirubin levels measured by UnaG fluorescence imaging showed favorable correlations with the results of the conventional light-absorptiometric methods (indirect bilirubin: rs = 0.939, p < 0.001; direct bilirubin: rs = 0.929, p < 0.001). Approximate time required for bilirubin measurements with UnaG was 15 min, whereas it took about 40 min with the conventional method at a hospital laboratory. Following administration of UnaG on hepatic surfaces, the fluorescence imaging identified bile leaks not only on the resected specimens but also in the abdominal cavity of the swine hepatectomy models. Fluorescence imaging techniques using UnaG may enable real-time identification of bile leaks during hepatectomy and on-site rapid diagnosis of bile leaks after surgery.
Medical subject headings
- Bile
- Bilirubin