Response to Comment on "Eppur si Muove: Proton Diffusion in Halide Perovskite Single Crystals": Measure What is Measurable, and Make Measurable What is Not So: Discrepancies between Proton Diffusion in Halide Perovskite Single Crystals and Thin Films.
other
Where this comes from
- Record sourced from PubMed, PMID 34308550.
- Also identified by DOI 10.1002/adma.202102822.
- No licence information is recorded for this record.
- Because redistribution is not established, this page shows the abstract only. Follow the links below for the full text.
Abstract
Buffeteau et al. note that the proton diffusion coefficient in MAPbI<sub>3</sub> that is deduced (by the authors) from results, obtained by a suite of complementary techniques, on a large number of single crystals (Adv. Mater. 2020, 32, 2002467) is 5 orders of magnitude higher than what is estimated (by them) in J. Am. Chem. Soc. 2020, 142, 10431, from infrared spectroscopy on ultrathin MAPbI<sub>3</sub> films; use of (deuterium/hydrogen) D/H isotope substitution is common to both studies. Buffeteau et al. speculated that proton diffusion in halide perovskite single crystals is dominated by 1D defects, which will somehow not be present in thin films, as those are made up of small-sized crystallites. It is shown here that the idea of a 1D defect is not supported by the body of experimental data gathered on these crystals, that the statistical analysis employed in to Buffeteau et al. to support the criticism is problematic, and it is concluded that the source of the difference must lie elsewhere. Constructive suggestions for this difference are provided and experiments to discern between possible reasons for it are proposed.