Full Characterization of in vivo Muscle as an Elastic, Incompressible, Transversely Isotropic Material Using Ultrasonic Rotational 3D Shear Wave Elasticity Imaging.
basic_science · Level V
Where this comes from
- Record sourced from PubMed, PMID 34415833.
- Also identified by DOI 10.1109/TMI.2021.3106278 and PMC identifier 8754054.
- No licence information is recorded for this record.
- Because redistribution is not established, this page shows the abstract only. Follow the links below for the full text.
Abstract
Using a 3D rotational shear wave elasticity imaging (SWEI) setup, 3D shear wave data were acquired in the vastus lateralis of a healthy volunteer. The innate tilt between the transducer face and the muscle fibers results in the excitation of multiple shear wave modes, allowing for more complete characterization of muscle as an elastic, incompressible, transversely isotropic (ITI) material. The ability to measure both the shear vertical (SV) and shear horizontal (SH) wave speed allows for measurement of three independent parameters needed for full ITI material characterization: the longitudinal shear modulus μ<sub>L</sub> , the transverse shear modulus μ<sub>T</sub> , and the tensile anisotropy χ<sub>E</sub> . Herein we develop and validate methodology to estimate these parameters and measure them in vivo, with μ<sub>L</sub> = 5.77±1.00 kPa, μ<sub>T</sub> = 1.93±0.41 kPa (giving shear anisotropy χ<sub>μ</sub> = 2.11±0.92 ), and χ<sub>E</sub> = 4.67±1.40 in a relaxed vastus lateralis muscle. We also demonstrate that 3D SWEI can be used to more accurately characterize muscle mechanical properties as compared to 2D SWEI.
Medical subject headings
- Elasticity Imaging Techniques
- Ultrasonics