Improving the alkali metal electrode/inorganic solid electrolyte contact via room-temperature ultrasound solid welding.
basic_science · Level V
Where this comes from
- Record sourced from PubMed, PMID 34876588.
- Also identified by DOI 10.1038/s41467-021-27473-4 and PMC identifier 8651668.
- No licence information is recorded for this record.
- Because redistribution is not established, this page shows the abstract only. Follow the links below for the full text.
Abstract
The combination of alkali metal electrodes and solid-state electrolytes is considered a promising strategy to develop high-energy rechargeable batteries. However, the practical applications of these two components are hindered by the large interfacial resistance and growth of detrimental alkali metal depositions (e.g., dendrites) during cycling originated by the unsatisfactory electrode/solid electrolyte contact. To tackle these issues, we propose a room temperature ultrasound solid welding strategy to improve the contact between Na metal and Na<sub>3</sub>Zr<sub>2</sub>Si<sub>2</sub>PO<sub>12</sub> (NZSP) inorganic solid electrolyte. Symmetrical Na|NZSP | Na cells assembled via ultrasonic welding show stable Na plating/stripping behavior at a current density of 0.2 mA cm<sup>-2</sup> and a higher critical current density (i.e., 0.6 mA cm<sup>-2</sup>) and lower interfacial impedance than the symmetric cells assembled without the ultrasonic welding strategy. The beneficial effect of the ultrasound welding is also demonstrated in Na|NZSP | Na<sub>3</sub>V<sub>2</sub>(PO<sub>4</sub>)<sub>3</sub> full coin cell configuration where 900 cycles at 0.1 mA cm<sup>-2</sup> with a capacity retention of almost 90% can be achieved at room temperature.