Facile construction of a highly proton-conductive matrix-mixed membrane based on a -SO₃H functionalized polyamide.

Abstract

Developing a facile strategy to construct low-cost and efficient proton-conductive electrolytes is pivotal in the practical application of proton exchange membrane (PEM) fuel cells. Herein, a polyamide with in-built -SO₃H moieties, PA(PhSO3H)2, was synthesized <i>via</i> a simple one-pot polymeric acylation process. Investigations <i>via</i> electrochemical impedance spectroscopy (EIS) measurements revealed that the fabricated PA(PhSO3H)2 displays a proton conductivity of up to 5.54 × 10^-2 S cm^-1 at 353 K under 98% relative humidity (RH), which is more than 2 orders of magnitude higher than that of its -SO₃H-free analogue PA(Ph)2 (2.38 × 10^-4 S cm^-1) under the same conditions. Therefore, after mixing with polyacrylonitrile (PAN) at different ratios, PA(PhSO3H)2-based matrix-mixed membranes were subsequently made and the analysis results revealed that the proton conductivity can reach up to 5.82 × 10^-2 S cm^-1 at 353 K and 98% RH when the weight ratio of PA(PhSO3H)2 : PAN is in 3 : 1 (labeled as PA(PhSO3H)2-PAN(3 : 1)), the value of which is comparable even to those of commercially available electrolytes that are used in PEM fuel cells. In addition, continuous testing shows that PA(PhSO3H)2-PAN(3 : 1) possesses long-life reusability. This work demonstrates that, utilizing the simple reaction of polymeric acylation with a sulfonated module as a precursor, highly effective proton-conductive membranes for PEM fuel cells can be achieved in a facile manner.