Effect of different fixation methods on biomechanical property of cervical vertebral body replacement and fusion.

Abstract

The main purpose of this study was to examine the effect of different fixation methods (anterior fixation, self-stabilizing fixation and anterior-posterior fixation) on biomechanical property of vertebral body replacement and fusion. Three finite element models of cervical vertebral body replacement and fusion were established. The implanted models included artificial vertebral body and fixation system, and the loads imposed on the models included 75 N compression load and 1 Nm moment load. For anterior-posterior fixation, the cervical load was mainly transmitted by the posterior pedicle screw and rod (more than 50%), and the stress shielding problem was the most significant than the self-stabilizing and anterior fixation. Self-stabilizing fixation was more helpful to the fusion of implant and vertebrae, but the higher risk of vertebral body collapse was worthy of attention if the cervical spine with osteoporosis. The stress of bone was mainly concentrated around the screw hole. The maximum stress (20.03 MPa) was lower than the yield stress of cortical bone and the possibility of fracture around the fixation device of cervical spine was low. The anterior fixation could meet the requirement of vertebral body replacement and fusion, and the addition of posterior pedicle screws and rods might obtain better treatment in cases of severe spine injury or osteoporosis. The findings of this study may provide guidance on clinical treatments for choosing more appropriate fixation methods for different patients.