Biomechanics of a collum-fixated short stem in total hip arthroplasty.
retrospective_cohort · Level III
Where this comes from
- Record sourced from PubMed, PMID 38435312.
- Also identified by DOI 10.1016/j.jor.2024.02.027 and PMC identifier 10901692.
- Licence recorded as CC BY.
- The licence permits redistribution, so the abstract is shown in full and the full text is available from the publisher.
Abstract
Biomechanical reconstruction of the hip significantly impacts the clinical outcome and implant survival. Our knowledge is limited of the ability of neck-stabilised prostheses to restore hip biomechanics. We hypothesised that hip biomechanics, specifically leg length and global offset (GO), may be restored to an acceptable range using the Primoris™ stem. In this retrospective study, we analysed 152 patients who underwent total hip replacement (THA) using the short collum-fixated stem Primoris™.The primary outcomes were hip parameters measured by x-ray following THA using the Primoris™ stem. After surgery, the biomechanical parameters used were measured at the arthroplasty and the native contralateral side of the same x-ray. The X-rays were taken one year after the patient's surgery.1. GO.2. Leg length discrepancy (LLD).3. Neck shaft angle (NSA). We recorded an average GO of -3.4 mm (standard deviation (SD) 7.2) and an average LLD of +3.8 mm (SD 6.4). Furthermore, we registered an average 14-degree NSA increase (SD 7.4). The Primoris™ neck-stabilised stem enabled hip anatomy restoration to a favourable range with respect to GO and LLD as the average difference fell within ±5 mm. However, the stem tended to be implanted in valgus.
Anatomy
- hip