Enhanced Synaptic Memory Window and Linearity in Planar In<sub>2</sub>Se<sub>3</sub> Ferroelectric Junctions.
basic_science · Level V
Where this comes from
- Record sourced from PubMed, PMID 39707639.
- Also identified by DOI 10.1002/adma.202413178.
- No licence information is recorded for this record.
- Because redistribution is not established, this page shows the abstract only. Follow the links below for the full text.
Abstract
A synaptic memristor using 2D ferroelectric junctions is a promising candidate for future neuromorphic computing with ultra-low power consumption, parallel computing, and adaptive scalable computing technologies. However, its utilization is restricted due to the limited operational voltage memory window and low on/off current (I<sub>ON/OFF</sub>) ratio of the memristor devices. Here, it is demonstrated that synaptic operations of 2D In<sub>2</sub>Se<sub>3</sub> ferroelectric junctions in a planar memristor architecture can reach a voltage memory window as high as 16 V (±8 V) and I<sub>ON/OFF</sub> ratio of 10<sup>8</sup>, significantly higher than the current literature values. The power consumption is 10<sup>-5</sup> W at the on state, demonstrating low power usage while maintaining a large I<sub>ON/OFF</sub> ratio of 10<sup>8</sup> compared to other ferroelectric devices. Moreover, the developed ferroelectric junction mimicked synaptic plasticity through pulses in the pre-synapse. The nonlinearity factors are obtained 1.25 for LTP, -0.25 for LTD, respectively. The single-layer perceptron (SLP) and convolutional neural network (CNN) on-chip training results in an accuracy of up to 90%, compared to the 91% in an ideal synapse device. Furthermore, the incorporation of a 3 nm thick SiO<sub>2</sub> interface between the α-In<sub>2</sub>Se<sub>3</sub> and the Au electrode resulted in ultrahigh performance among other 2D ferroelectric junction devices to date.