Enabling ultra-flexible inorganic thin-film-based thermoelectric devices by introducing nanoscale titanium layers.
basic_science · Level V
Where this comes from
- Record sourced from PubMed, PMID 39805848.
- Also identified by DOI 10.1038/s41467-025-56015-5 and PMC identifier 11730660.
- Licence recorded as CC BY-NC-ND.
- Because redistribution is not established, this page shows the abstract only. Follow the links below for the full text.
Abstract
Here, we design exotic interfaces within a flexible thermoelectric device, incorporating a polyimide substrate, Ti contact layer, Cu electrode, Ti barrier layer, and thermoelectric thin film. The device features 162 pairs of thin-film legs with high room-temperature performance, using p-Bi<sub>0.5</sub>Sb<sub>1.5</sub>Te<sub>3</sub> and n-Bi<sub>2</sub>Te<sub>2.7</sub>Se<sub>0.3</sub>, with figure-of-merit values of 1.39 and 1.44, respectively. The 10 nm Ti contact layer creates a strong bond between the substrate and the Cu electrode, while the 10 nm Ti barrier layer significantly reduces internal resistance and enhances the tightness between thermoelectric thin films and Cu electrodes. This enables both exceptional flexibility and an impressive power density of 108 μW cm<sup>-2</sup> under a temperature difference of just 5 K, with a normalized power density exceeding 4 μW cm<sup>-2</sup> K<sup>-2</sup>. When attached to a 50 °C irregular heat source, three series-connected devices generate 1.85 V, powering a light-emitting diode without the need for an additional heat sink or booster.