Interfacial bonding enhances thermoelectric cooling in 3D-printed materials.
basic_science · Level V
Where this comes from
- Record sourced from PubMed, PMID 39977506.
- Also identified by DOI 10.1126/science.ads0426.
- No licence information is recorded for this record.
- Because redistribution is not established, this page shows the abstract only. Follow the links below for the full text.
Abstract
Thermoelectric coolers (TECs) are pivotal in modern heat management but face limitations in efficiency and manufacturing scalability. We address these challenges by using an extrusion-based 3D printing technique to fabricate high-performance thermoelectric materials. Our ink formulations ensure the integrity of the 3D-printed structure and effective particle bonding during sintering, achieving record-high figure of merit (<i>zT</i>) values of 1.42 for p-type bismuth antimony telluride [(Bi,Sb)<sub>2</sub>Te<sub>3</sub>] and 1.3 for n-type silver selenide (Ag<sub>2</sub>Se) materials at room temperature. The resulting TEC demonstrates a cooling temperature gradient of 50°C in air. Moreover, this scalable and cost-effective method circumvents energy-intensive and time-consuming steps, such as ingot preparation and subsequently machining processes, offering a transformative solution for thermoelectric device production and heralding a new era of efficient and sustainable thermoelectric technologies.