Single atom Ru-supported reduced graphene oxide integrated self-assembled monolayer as a nm-scale Cu diffusion barrier.
basic_science · Level V
Where this comes from
- Record sourced from PubMed, PMID 41422265.
- Also identified by DOI 10.1038/s41467-025-67668-7 and PMC identifier 12830982.
- Licence recorded as CC BY-NC-ND.
- Because redistribution is not established, this page shows the abstract only. Follow the links below for the full text.
Abstract
In advanced integrated circuits, signal transmission delay arising from interconnect resistance is a main problem hindering the development of electronic devices, while the conventional several-nanometer-thick TaN/Ta barrier with high resistivity causes a surge in interconnect resistance due to the size effect. To address this issue, it is crucial to develop Cu barrier materials. Here, we design an integrated ultra-thin Cu diffusion barrier (~1.4 nm) consisting of single-atom Ru-supported reduced graphene oxide (Ru SA-rGO) and self-assembled monolayer (SAM) derived from (3-aminopropyl)triethoxysilane, which combines the dual functions of liner and barrier. The supporting of Ru requires N-doping as a bridge. Remarkably, the mean time-to-failure of devices with Ru SA-rGO/SAM is approximately 24 times longer than barrier-free devices. Ru atoms can both physically block Cu diffusion by filling rGO vacancies and chemically capture Cu through enhanced adsorption. Our work provides insight into diffusion barrier development in advanced Cu interconnects.