Reconfigurable mmWave microchips co-integrating hBN switches on GaN.
basic_science · Level V
Where this comes from
- Record sourced from PubMed, PMID 42420456.
- Also identified by DOI 10.1038/s41586-026-10761-8.
- No licence information is recorded for this record.
- Because redistribution is not established, this page shows the abstract only. Follow the links below for the full text.
Abstract
Monolithic microwave integrated circuits (MMICs) are an emerging technology that is expected to substantially improve telecommunications in the next few years<sup>1,2</sup>. MMICs use application-specific semiconductors to meet the performance needs of 5G standards and beyond; however, integrating high-frequency switches into these platforms is very demanding in terms of area and cost and doing so is also a bottleneck for performance<sup>3</sup>. Memristive radio-frequency switches are an appealing alternative due to their easy fabrication and high device-level electrical performance, but their use in circuit implementations of MMICs has never been realized<sup>4</sup>. Here we demonstrate programmable millimetre-wave (mmWave) gallium nitride (GaN) MMICs fabricated with memristive radio-frequency switches made from two-dimensional layered hexagonal boron nitride (hBN) integrated directly on the back-end-of-line. We fabricated back-end-of-line wideband switches operating up to 100 GHz with insertion losses as low as 0.3 dB and isolation better than 15 dB. The switches delivered long-term state retention (2 weeks), stable on-state resistance at 175 °C, linear power handling within 0.28 dB measured up to 18 dBm, and an extrapolated 1-dB compression point mean of 30.52 dBm. We use one-transistor, one-memristor cell integration for the switch drivers, achieving 3,250 cycles of endurance, an improvement for two-dimensional-material-based memristive radio-frequency switches. Finally, we demonstrate the implementation of memristive-configurable attenuators, power dividers and programmable resonators on the GaN MMIC platform.