A ring-jig additive friction stir deposition method for efficient additive manufacturing of metal laminates.
basic_science · Level V
Where this comes from
- Record sourced from PubMed, PMID 42532996.
- Also identified by DOI 10.1038/s41467-026-75350-9 and PMC identifier 13424571.
- Licence recorded as CC BY-NC-ND.
- Because redistribution is not established, this page shows the abstract only. Follow the links below for the full text.
Abstract
Metal additive manufacturing (AM) has attracted attention for producing high-mix, low-volume, meter-scale components, especially for industrial applications. However, conventional AM requires high-energy input, expensive powders, and long processing times, limiting scalability and cost-effectiveness. To overcome these challenges, solid-state AM methods are being explored for lower energy use and higher build rates. This study presents a solid-state AM technique derived from friction surfacing, in which uniform layers are formed by direct friction between a rotating metal bar and a substrate. The proposed method achieves a maximum build rate of 8,000 cm³ h<sup>-1</sup>, while fusion-based AM method achieves 800 cm<sup>3 </sup>h<sup>-1</sup> and conventional solid-state AM method achieves 2400 cm<sup>3 </sup>h<sup>-1</sup> in maximum. Compared with other processes, the proposed method offers significant gains in deposition speed. Combining high build rate with sound interfacial bonding, the proposed method provides a promising approach for scalable, cost-effective production of large structural metal components.