Evaluation of application techniques of fibrin sealant to prevent cerebrospinal fluid leakage: a new device for the application of aerosolized fibrin glue.

Abstract

This report evaluates the sealing effects of fibrin sealant applied on the dura mater using different techniques. Three application methods were studied: a sequential layer method, a simultaneous method using a cannula, and a spray method using a newly developed spray device. The sealing effects of these methods were compared using in vitro histological analysis and a pressure resistance test. The clinical efficacy of the fibrin sealant to prevent water leakage through the dura mater was retrospectively analyzed in a total of 509 patients. The process of absorption of a clinically applied fibrin clot in vivo was examined using surgical specimens. The fibrin plate made using the spray method withstood a hydrostatic pressure greater than 200 cm H2O. A scanning electron microscopic study of the fibrin clots showed that the sequential and simultaneous methods produced a fibrin fiber network; in contrast, our spray method formed a dense fibrin tissue in which the fibrin molecules fused together forming stratified laminae. Of the 295 supratentorial craniotomies during which spraying was used, postsurgical cerebrospinal fluid leakage occurred in 9 cases (3.1%), whereas of the 214 craniotomies during which spraying was not used, cerebrospinal fluid leakage occurred in 19 cases (8.9%). Histological examinations of 10 surgical specimens obtained during second craniotomies revealed that the spray-made fibrin clots had been gradually replaced by mature granulation composed of collagenous connective tissue. The optimal technique for applying fibrin sealant is the spray method that aerosolizes fibrin glue and produces a tough fibrin plate.